Retransmit Interval...................... 5
Hello Interval........................... 10
Dead Interval............................ 40
LSA Ack Interval......................... 1
Iftransit Delay Interval................. 1
Authentication Type...................... None
Metric Cost.............................. 10
OSPF Mtu-ignore.......................... Disable
OSPF Interface Type...................... broadcast
State.................................... backup-designated-router
Designated Router........................ 1.1.1.1
Backup Designated Router................. 2.2.2.2
Number of Link Events.................... 46
show ipv6 ospf neighbor
Use the show ipv6 ospf neighbor command in Privileged EXEC mode to display information
about OSPF neighbors. If a neighbor IP address is not specified, the output displays summary
information in a table. If an interface or tunnel is specified, only the information for that
interface or tunnel displays. The information below only displays if OSPF is enabled and the
interface has a neighbor.
Syntax
show ipv6 ospf neighbor [ interface { vlan
vlan-id — Valid VLAN ID.
•
tunnel-id — Tunnel identifier. (Range: 0-7)
•
ip-address — Is the valid IP address of the neighbor about which information is displayed.
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
vlan-id
tunnel-id
| tunnel
(computed)
ip-address
} ] [
]
835