Dell PowerConnect M6348 Cli Reference Manual page 643

no ipv6 mld snooping groupmembership-interval [vlan-id]
• vlan_id — Specifies a VLAN ID value in VLAN Database mode.
• seconds — MLD group membership interval time in seconds. (Range: 2-3600)
Default Configuration
The default group membership interval time is 260 seconds.
Command Mode
Interface Configuration mode.
VLAN Database mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-4/g1)#ipv6 mld snooping groupmembership-interval
300
ipv6 mld snooping maxresponse
The ipv6 mld snooping maxresponse command sets the MLD Maximum Response time for an
interface or VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for a
particular group in that interface. This value must be less than the MLD Query Interval time
value. The range is 1 to 3599 seconds.
Syntax
ipv6 mld snooping maxresponse [vlan-id] [seconds]
no ipv6 mld snooping maxresponse [vlan-id]
• vlan_id — Specifies a VLAN ID value in VLAN Database mode.
• seconds — MLD maximum response time in seconds. (Range: 1–3599)
Default Configuration
The default maximum response time is 10 seconds.
Command Mode
Interface Configuration mode.
VLAN Database mode.
643