Dell PowerConnect M6348 Cli Reference Manual page 873

User Guidelines
This command has no user guidelines.
Examples
The following examples show the parameters related to an individual tunnel and to all tunnel
interfaces.
console#show interfaces tunnel 1
Interface Link Status.......................... down
MTU size....................................... 1480 bytes
console#show interfaces tunnel
TunnelId Interface
-------- ---------
1 tunnel 1
2 tunnel 2
tunnel destination
Use the tunnel destination command in Interface Configuration mode to specify the
destination transport address of the tunnel.
Syntax
ipv4addr
tunnel destination
no tunnel destination
ipv4addr — Valid ipv4 address.
•
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies the destination transport address of tunnel 1.
TunnelMode SourceAddress
---------- -------------
IPv6OVER4 10.254.25.14
IPv6OVER4
DestinationAddress
----------------
10.254.25.10
10.254.20.10
873