Dell PowerConnect M6348 Cli Reference Manual page 295

Example
console(config)#interface out-of-band
console(config-if)#
ip address
Use the ip address command in Global Configuration mode to set an IP address. To remove an
IP address, use the no form of this command.
Syntax
ip address {bootp|dhcp|none|
no ip address
• bootp--Sets protocol to bootp
• dhcp--Sets protocol to dhcp
• none--No protocol is set
ipaddress — Specifies a valid IP address.
•
mask — Specifies a valid subnet (network) mask IP address.
•
• prefix-length — The number of bits that comprise the IP address prefix. The prefix length
must be preceded by a forward slash (/). (Range: 1-30)
Default Configuration
The switch management interface is unconfigured by default.
Command Mode
Global Configuration mode
User Guidelines
DHCP cannot be enabled on the management interface and the out-of-band interface at the
same time.
Examples
The following example acquires an IP address for the switch management interface from DHCP .
console(config)#ip address dhcp
The following examples configure the IP address 131.108.1.27 and subnet mask 255.255.255.0
and the same IP address with prefix length of 24 bits.
<ipaddress> mask prefix-length
{ | }}
295