Dell PowerConnect M6348 Cli Reference Manual page 168

User Guidelines
NOTE: LAG and VLAN interfaces are only supported by PCM6220.
This command has no user guidelines.
Examples
• Bind the IP ACL named myipacl to the physical interface 1/g1 in the outbound direction.
console(config-if-1/g1)#ip access-group myipacl out
• Bind the IP ACL named myipacl to the LAG interface 1 in the outbound direction.
console(config-if-ch1)#ip access-group myipacl out
• Bind the IP ACL named myipacl to the VLAN interface 999 in the outbound direction.
console(config-if-vlan999)#ip access-group myipacl out
mac access-group
Use the mac access-group command in Global Configuration or Interface Configuration mode
to attach a specific MAC Access Control List (ACL) to an interface in a given direction.
Syntax
mac access-group
no mac access-group
• name — Name of the existing MAC access list. (Range: 1-31 characters)
direction — Direction of the ACL. (Range: In or out. Default is in .)
•
sequence — Order of access list relative to other access lists already assigned to this interface
•
and direction. (Range: 1-4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode or Interface Configuration (Ethernet, VLAN or Port Channel)
mode
User Guidelines
NOTE: MAC Access Groups are only supported by PCM6220.
specified to indicate the order of this access-list relative to the other access-lists already assigned
to this interface and direction. A lower number indicates higher precedence order. If a sequence
number already is in use for this interface and direction, the specified access-list replaces the
168
name direction sequence
name
An optional sequence number may be