Dell PowerConnect M6348 Cli Reference Manual page 931

seconds — Polling interval. (Range: 64-1024 seconds, in powers of 2)
•
Default Configuration
The polling interval is 64 seconds.
Command Mode
Global Configuration mode
User Guidelines
If a user enters a value which is not an exact power of two, the nearest power-of-two value is
applied.
Example
The following example sets the polling time for the Simple Network Time Protocol (SNTP)
client to 1024 seconds.
console(config)# sntp client poll timer 1024
sntp server
Use the sntp server command in Global Configuration mode to configure the device to use
Simple Network Time Protocol (SNTP) to request and accept SNTP traffic from a specified
server. To remove a server from the list of SNTP servers, use the no form of this command.
Syntax
ip-address
sntp server {
ip-address
no sntp server
ip-address — IP address of the server.
•
hostname — Hostname of the server. (Range: 1-158 characters)
•
poll — Enables polling.
•
key-number — Authentication key to use when sending packets to this peer.
•
(Range: 1-4294967295)
priority — Priority assigned to the server. (Range: 1–8)
•
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
hostname
| } [priority
priority key-number
] [poll] [key ]
931