ip mcast boundary
Use the ip mcast boundary command in Interface Configuration mode to add an administrative
scope multicast boundary specified by
administrative boundary is applicable.
mask.
Syntax
groupipaddr mask
ip mcast boundary
no ip mcast boundary
groupipaddr — IP address of multicast group. Valid range is 239.0.0.0 to 239.255.255.255.
•
mask — IP mask of multicast group.
•
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds an administrative scope multicast boundary.
console(config)#interface vlan 15
console(config-if-vlan15)#ip mcast boundary 239.5.5.5
255.255.255.255
ip mroute
Use the ip mroute command to create a static multicast route for a source range. Use the "no"
form of this command to delete a static multicast route.
Syntax
source-address source-mask rpf-address preference
ip mroute
source-address source
no ip mroute
source-address — The IP address of the multicast data source.
•
source-mask — The IP subnet mask of the multicast data source.
•
groupipaddr
groupipaddr
groupipaddr mask
mask
and
for which this multicast
is a group IP address and
mask
is a group IP
717