Sflow Sampling (Interface Mode) - Dell PowerConnect M6348 Cli Reference Manual

interfaces — The list of interfaces to poll.
•
sampling-rate — The statistical sampling rate for packet sampling from this source. A
•
sampling rate of 1 counts all packets. A rate of 0 disables sampling. A value of n means that
out of n incoming packets, 1 packet will be sampled. (Range: 1024–65536).
size — The maximum number of bytes that should be copied from the sampler packet
•
(Range: 20–256 bytes).
Default Configuration
There are no samplers configured by default.
The default sampling rate is 0.
The default maximum header size is 128.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#sflow 1 sampling ethernet 1/g2 1500 50

sflow sampling (Interface Mode)

Use the sflow sampling command in Interface Mode to enable a new sflow sampler instance for
this data source if rcvr_idx is valid. Use the "no" form of this command to reset sampler
parameters to the default.
Syntax
rcvr-index
sflow sampling
rcvr-index
no sflow sampling
rcvr-index — The sFlow Receiver for this sFlow sampler to which flow samples are to be sent.
•
If no receiver is configured, then no packets will be sampled. Only active receivers can be set.
If a receiver expires, then all samplers associated with the receiver will also expire. (Range: 1 -
8).
sampling-rate — The statistical sampling rate for packet sampling from this source. A
•
sampling rate of 1 counts all packets. A rate of 0 disables sampling. A value of n means that
out of n incoming packets, 1 packet will be sampled. (Range: 1024 - 65536).
sampling-rate size
[ ]
1031