Ipv6 Ospf Dead-Interval - Dell PowerConnect M6348 Cli Reference Manual

Default Configuration
10 is the default value of
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a cost of 100.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf cost 100

ipv6 ospf dead-interval

Use the ipv6 ospf dead-interval command in Interface Configuration mode to set the OSPF
dead interval for the specified interface.
Syntax
ipv6 ospf dead-interval
no ipv6 ospf dead-interval
seconds — A valid positive integer, which represents the length of time in seconds that a
•
router's Hello packets have not been seen before its neighbor routers declare that the router is
down. The value for the length of time must be the same for all routers attached to a common
network. This value should be some multiple of the Hello Interval (i.e. 4). (Range: 1-65535)
Default Configuration
40 seconds is the default value of
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF dead interval at 100 seconds.
814
cost
.
seconds
seconds
.