ipv6 mld last-member-query-interval
The ipv6 mld last-member-query-interval command sets the last member query interval for the
MLD interface, which is the value of the maximum response time parameter in the group-
specific queries sent out of this interface. Use the "no" form of this command to set the last
member query interval to the default.
Syntax
ipv6 mld last-member-query-interval
no ipv6 mld last-member-query-interval
last-member-query-interval — The last member query interval (Range: 0–65535
•
milliseconds).
Default Configuration
The default last member query interval is 1 second.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-interval 5000
ipv6 mld-proxy
Use the ipv6 mld-proxy command to enable MLD Proxy on the router. To enable MLD Proxy
on the router, you must also enable multicast forwarding. Also, ensure that there are no other
multicast routing protocols enabled on the router. Use the "no" form of this command to
disable MLD Proxy.
Syntax
ipv6 mld-proxy
no ipv6 mld-proxy
Default Configuration
MLD Proxy is disabled by default.
670
last-member-query-interval