Dell PowerConnect M6348 Cli Reference Manual page 683

next-hop-address — Is the IPv6 address of the next hop that can be used to reach the
•
specified network.
preference — Is a value the router uses to compare this route with routes from other route
•
sources that have the same destination. (Range: 1-255)
Default Configuration
1 is the default value for
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configure an IPv6 static route.
console(config)#ipv6 route 2020:1::1/64 2030:1::2
ipv6 route distance
Use the ipv6 route distance command in Global Configuration mode to set the default distance
(preference) for static routes. Lower route preference values are preferred when determining the
best route. The ipv6 route and ipv6 route default commands allow optional setting of the
distance of an individual static route. The default distance is used when no distance is specified
in these commands. Changing the default distance does not update the distance of existing
static routes, even if they were assigned the original default distance. The new default distance
is applied to static routes created after invoking the ipv6 route distance command.
Syntax
ipv6 route distance integer
no ipv6 route distance
integer — Specifies the distance (preference) of an individual static route. (Range 1-255)
•
Default Configuration
integer
Default value of
Command Mode
Global Configuration mode
preference
.
integer
is 1.
683