Dell PowerConnect M6348 Cli Reference Manual page 370

User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 2
console(config-aggregator-2)#lacp off
console(config-aggregator-2)#
lacp static
Use the lacp static command to set the LACP (Link Aggregation) mode to static for that Aggregator
Group. This means that when more than one uplink port is in the Group, those uplink ports will be
enabled automatically with static LACP.
Syntax
lacp static
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 2
console(config-aggregator-2)#lacp static
console(config-aggregator-2)#
minimum active uplinks
Use the minimum active uplinks command to set the minimum number of uplinks to be active for the
Group. For example, if the number of uplink ports in the group is 2 and the number of internal ports is 4.
If the user sets the minimum active uplink ports to be 2, then both the uplink ports should be active;
370