Dell PowerConnect M6348 Cli Reference Manual page 277

User Guidelines
This command has no user guidelines.
Example
The following example configures the mrouter timeout to 200 seconds.
console(config-if-1/g1)#ip igmp snooping mrouter-time-out 200
show ip igmp snooping groups
Use the show ip igmp snooping groups command in User EXEC mode to display the Multicast groups
learned by IGMP snooping.
Syntax
show ip igmp snooping groups [vlan
vlan_id — Specifies a VLAN ID value.
•
• ip-multicast-address — Specifies an IP Multicast address.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
To see the full Multicast address table (including static addresses) use the show bridge address-table
command.
Example
The example shows Multicast groups learned by IGMP snooping for all VLANs.
console>show ip igmp snooping groups
Vlan IP Address
---- -----------
1 224-239.130|2.2.3
19 224-239.130|2.2.8
IGMP Reporters that are forbidden statically:
vlan-id ip-multicast-address
] [address
Ports
-------
1/g1, 2/g2
1/g9-g11
]
277