Dell PowerConnect M6348 Cli Reference Manual page 634

Routing Protocol is "ospf"
Redistributing: OSPF, External direct, Static, RIP
Interfaces:
Interface Metric Key-chain
-------- --------- ----------- ----------
176.1.1.1 10 flowers
176.2.1.1 1
Routing Information Sources:
Gateway State
176.1.1.2 Full
External Preference: 60
Internal Preference: 20
show ip route
Use the show ip route command in Privileged EXEC mode to display the routing table.
Syntax
show ip route [
protocol — Specifies the protocol that installed the routes. (Range: connected, ospf, rip
•
static)
ip-address — Specifies the network for which the route is to be displayed and displays the best
•
matching best-route for the address.
subnet-mask — Subnet mask of the IP address.
•
prefix-length — Length of prefix, in bits. Must be preceded with a forward slash ('/'). (Range:
•
0-32 bits)
• longer-prefixes — Indicates that the
the command displays the routes to the addresses that match that prefix.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
634
protocol ip-address
|address
subnet-mask prefix-length
[ |
ip-address and subnet-mask pair becomes the prefix, and
] [longer-prefixes]]