Dell PowerConnect M6348 Cli Reference Manual page 773

RFC 1583
Compatibility
Opaque Capability
ABR Status
Exit Overflow Interval
External LSA Count
External LSA
Checksum
AS_OPAQUE LSA
Count
AS_OPAQUE LSA
New LSAs Originated
LSAs Received
External LSDB Limit
Default Metric
Default Route Advertise Indicates whether the default routes received from other source protocols are
Always
Metric
Metric Type
Maximum Paths
Redistributing
Source
Tag
Subnets
Distribute-List
Reflects whether 1583 compatibility is enabled or disabled. This is a configured
value.
Shows whether router is capable of sending Opaque LSA's. This is a configured
value.
Shows whether the router is an OSPF Area Border Router.
Shows the number of seconds that, after entering OverflowState, a router will
attempt to leave OverflowState.
Shows the number of external (LS type 5) link-state advertisements in the link-
state database.
Shows the sum of the LS checksums of external link-state advertisements
contained in the link-state database.
Shows the number of AS Opaque LSA's received.
Checksum Shows the Checksum of received AS Opaque LSA's
Shows the number of new link-state advertisements that have been originated.
Shows the number of link-state advertisements received determined to be new
instantiations.
Shows the maximum number of non-default AS-external-LSAs entries that can
be stored in the link-state database.
Default value for redistributed routes.
advertised or not
Shows whether default routes are always advertised.
Shows the metric for the advertised default routes. If the metric is not
configured, this field is blank.
Shows whether the routes are External Type 1 or External Type 2.
Shows the maximum number of paths that OSPF can report for a given
destination.
This field is a heading and appears only if you configure the system to take
routes learned from a non-OSPF source and advertise them to its peers.
Shows source protocol/routes that are being redistributed. Possible values are
static, connected, BGP , or RIP.
Shows the decimal value attached to each external route.
For redistributing routes into OSPF, the scope of redistribution for the specified
protocol.
Shows the access list used to filter redistributed routes.
773