Dell PowerConnect M6348 Cli Reference Manual page 174

bridge address
Use the bridge address command in Interface Configuration mode to add a static MAC-layer
station source address to the bridge table. To delete the MAC address, use the no form of the
bridge address command (using the no form of the command without specifying a MAC
address deletes all static MAC addresses belonging to this VLAN).
Syntax
bridge address
[permanent]
no bridge address [
mac-address — A valid MAC address in the format xxxx.xxxx.xxxx.
•
interface — A valid Ethernet port.
•
port-channel-number — A valid port-channel number.
•
• permanent — The address can be deleted only by using the no bridge address command.
Default Configuration
No static addresses are defined. The default mode for an added address is permanent.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds a permanent static MAC-layer station source address
3aa2.64b3.a245 to the bridge table.
console(config-if-vlan1)#bridge address 3AA2.64B3.A245 ethernet
1/g8 permanent
bridge aging-time
Use the bridge aging-time command in Global Configuration mode to set the aging time of the
address. To restore the default, use the no form of the bridge aging-time command.
Syntax
bridge aging-time
no bridge aging-time
174
mac-address
{ethernet
mac-address
]
seconds
interface
|port-channel
port-channel-number
}