Dell PowerConnect M6348 Cli Reference Manual page 196

User Guidelines
There are no user guidelines for this command.
Example
The following example enables isdp on interface 1/g1.
console(config)#interface ethernet 1/g1
console(config-if-1/g1)#isdp enable
isdp holdtime
The isdp holdtime command configures the hold time for ISDP packets that the switch
transmits. The hold time specifies how long a receiving device should store information sent in
the ISDP packet before discarding it. The range is given in seconds. Use the "no" form of this
command to reset the holdtime to the default.
Syntax
time
isdp holdtime
no isdp holdtime
time —The time in seconds (range 10–255 seconds).
•
Default Configuration
The default holdtime is 180 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets isdp holdtime to 40 seconds.
console(config)#isdp holdtime 40
isdp timer
The isdp timer command sets period of time between sending new ISDP packets. The range is
given in seconds. Use the "no" form of this command to reset the timer to the default.
196