Dell PowerConnect M6348 Cli Reference Manual page 347

lldp med transmit-tlv
This command is used to specify which optional TLVs in the LLDP MED set are transmitted in
the LLDPDUs. There are certain conditions that have to be met for this port to be MED
compliant. These conditions are explained in the normative section of the specification. For
example, the MED TLV 'capabilities' is mandatory. By disabling this bit, MED is effectively
disable on this interface.
Syntax Description
lldp med transmit-tlv [
no med lldp transmit-tlv [
Capabilities
• — Transmit the capabilities TLV
network-policy
• — Transmit the network policy TLV
ex-pse
• — Transmit the extended PSE TLV
ex-pd
• — Transmit the extended PD TLV
Location
• — Transmit the location TLV
Inventory
• — Transmit the inventory TLV
Parameter Ranges
Not applicable. Command accepts keywords only.
Command Mode
Interface (Ethernet) Configuration
Default Value
By default, the capabilities and network policy TLVs are included.
Example
console(config)#interface ethernet 1/g1
console(config-if-1/g1)#lldp med transmit-tlv capabilities
console(config-if-1/g1)#lldp med transmit-tlv network-policies
lldp notification
Use the lldp notification command in Interface Configuration mode to enable remote data
change notifications. To disable notifications, use the no form of this command.
capabilities network-policy
] [
capabilities network-policy
] [
ex-pse ex-pd location
] [ ] [ ] [
ex-pse ex-pd
] [ ] [ ] [
inventory
] [ ]
location inventory
] [ ]
347