Dell PowerConnect M6348 Cli Reference Manual page 313

Example
console(Config)#ipv6 access-list rename DELL_IP6 DELL_IP6_NEW_NAME
ipv6 traffic-filter
The ipv6 traffic-filter command either attaches a specific IPv6 Access Control List (ACL) to an
interface or associates it with a VLAN ID in a given direction.
An optional sequence number may be specified to indicate the order of this access list relative to
other IPv6 access lists already assigned to this interface and direction. A lower number indicates
higher precedence order. If a sequence number is already in use for this interface and direction,
the specified IPv6 access list replaces the currently attached IPv6 access list using that sequence
number. If the sequence number is not specified for this command, a sequence number that is
one greater than the highest sequence number currently in use for this interface and direction is
used.
Use the "no" form of the command to remove an IPv6 ACL from the interface(s) in a given
direction.
Syntax
name direction
ipv6 traffic-filter
name direction
no ipv6 traffic-filter
• name — Alphanumeric string of 1 to 31 characters uniquely identifying the IPv6 access list.
direction — Direction of the ACL. (Range: in or out)
•
seq-num — Order of access list relative to other access lists already assigned to this
• sequence
interface and direction. (Range: 1–4294967295)
Default Configuration
This command has no default configuration.
Command Modes
Global Configuration mode
Interface Configuration (Ethernet, Port-channel, VLAN) mode
User Guidelines
This command specified in 'Interface Config' mode only affects a single interface, whereas the
'Global Config' mode setting is applied to all interfaces.
Example
• The following example attaches an IPv6 access control list to an interface.
seq-num
[sequence ]
313