User Guidelines
This command has no user guidelines.
Example
In the following example, the end node uses DHCPv6.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd managed-config-flag
ipv6 nd ns-interval
Use the ipv6 nd ns-interval command in Interface Configuration mode to set the interval
between router advertisements for advertised neighbor solicitations. An advertised value of 0
means the interval is unspecified.
Syntax
milliseconds
ipv6 nd ns-interval
no ipv6 nd ns-interval
milliseconds — Interval duration. (Range: 0, 1000–4294967295)
•
Default Configuration
milliseconds
0 is the default value for
.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the interval between router advertisements for advertised neighbor
solicitations at 5000 ms.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd ns-interval 5000
ipv6 nd other-config-flag
Use the ipv6 nd other-config-flag command in Interface Configuration mode to set the "other
stateful configuration" flag in router advertisements sent from the interface.
676