Chapter 27 Ipv6 Interface Configuration; Create An Ipv6 Routing Interface - NETGEAR ProSafe GSM5212P Software Administration Manual

IPv6 Interface Configuration
27.
This chapter provides the following examples:
•

Create an IPv6 Routing Interface

• Create an IPv6 Network Interface
• Create an IPv6 Routing VLAN
• Configure DHCPv6 Mode on the Routing Interface
Create an IPv6 Routing Interface
The example is shown as CLI commands and as a Web interface procedure.
CLI: Create an IPv6 Routing Interface
1. Enable IPV6 forwarding and unicast routing on the switch.
(Netgear Switch) (Config)#ipv6 forwarding
(Netgear Switch) (Config)#ipv6 unicast-routing
on page 393
on page 395
on page 400
Chapter 27. IPv6 Interface Configuration
27
| 390