Table of Contents
Advertisement
To restart or reset the switch using the Reset button:
1. Insert a device such as a straightened paper clip into the opening.
2. Do one of the following:
• Restart the switch: Press the Reset button for 2 seconds. (Do not press the
button for 5 seconds!)
• Reset the switch to factory default settings: Press the Reset button for at least
5 seconds.
During the restart or reset process, the Power LED lights yellow.
USB 3.0 ports
The switch provides two USB 3.0 ports that let you connect the switch to storage devices,
upgrade firmware from a disk, back up the configuration, and allow for the collection
of a memory dump for debugging purposes.
A device that you attach to the USB port must comply with the following requirements:
• The USB device must support USB 3.0.
• The USB device must support the FAT32 or VFAT file type. The NTFS file type is not
supported.
Out-of-band 1G Ethernet port
The back panel of the switch provides one out-of-band (OOB) 1000BASE-T RJ-45
Ethernet port that lets you access the switch over its main UI or over a Telnet or SSH
session.
USB Type-C console port
The switch provides one USB Type-C console port for console access only. The product
package includes one USB console cable with a USB-A connector and a USB-C connector.
You can use this cable to connect the USB Type-C console port on the switch to a USB
port on a VT100-compatible terminal or a Windows-based computer that runs VT100
terminal emulation software.
Note: For you to be able to use the USB Type-C port and access the switch from a
Windows-based computer that runs VT100 terminal emulation software, you must install
the USB driver on the computer. To download the VT100 terminal emulation software
and Windows USB driver, visit netgear.com/support.
Hardware Overview
Fully Managed Switches M4350 Series
39
Hardware Installation Guide
Advertisement
Table of Contents
Troubleshooting
