Omron OMNUC G User Manual page 360

6-4 Setting the Mode
3. Returning to Copy Mode
Key
operation
Precautions
for Correct Use
6
Copying from the Parameter Unit to the Servo Drive
1. Displaying Copy Mode
Key
operation
2. Checking the Servo Drive Model Code
Key
operation
6-29
Display example
Press the
If
beginning. Press the
Do not disconnect the Parameter Unit from the Servo Drive while copying
is being performed. If the Parameter Unit is disconnected, connect it and
then repeat the procedure from the beginning.
If errors are repeatedly displayed, the following may be the cause: cable
disconnection, connector contact failure, incorrect operation due to noise,
or EEPROM fault in the Parameter Unit.
Display example
The item set for the Default Display (Pn001) is displayed.
Press the
Press the
Press the
eter Unit to the Servo Drive.
Display example
Press the
Press and hold the
If the model codes do not match, "DIFFER" will be displayed.
The bar indicator will increase when the key is pressed for 3 s or longer.
The bar indicator will increase.
The Servo Drive model code is being checked. If a different model code has
been entered, refer to 3. Different Model Codes on the next page to perform
the procedure.
If the model codes match, the display will proceed to the display in 4. Execut-
ing Copying.
Explanation
key to return to Copy Mode.
is displayed before completion, repeat the procedure from the
key to clear the error.
Explanation
key to display Monitor Mode.
key five times to display Copy Mode.
key to switch to the copy display for copying from the Param-
Explanation
key to switch to Copy Mode.
key until "EEP_CH" is displayed.