Parameter Write Mode - Omron OMNUC G User Manual

6-4 Setting the Mode

Parameter Write Mode

Settings changed in the Parameter Setting Mode must be saved to the EEPROM. To do so, the
following procedure must be performed.
1. Saving Changed Settings
Key
operation
6
2. Returning to Parameter Write Mode
Key
operation
Precautions
for Correct Use
6-23
Display example
Press the
Press the
Press the
The bar indicator will increase.
Writing will start. (This display will appear only momentarily.)
This display indicates a normal completion. In addition to the
either
writing has been completed normally, but some of the changed parameters
will be enabled only after the power has been turned OFF and ON again.
Turn OFF the Servo Drive power supply and then turn it ON again.
Display example
Press the
If a write error occurs, write the data again. If write errors continue to occur,
there may be a fault in the Servo Drive.
Do not turn OFF the power supply while writing to EEPROM. Incorrect data
may be written if the power supply is turned OFF. If the power supply is
turned OFF, perform the settings again for all parameters, and write the
data again.
Do not disconnect the Parameter Unit from the Servo Drive during the time
from writing start (
from the beginning.
Explanation
key to display Parameter Write Mode.
key to switch to Parameter Write Mode.
key for 5 s or longer.
or may be displayed. If
is displayed if there is a writing error. Write the data again.
Explanation
key to return to the Parameter Write Mode Display.
) to writing completion (
sktkakrktk k
). If the Parameter Unit is disconnected, repeat the procedure
,
is displayed,
or