Omron OMNUC G User Manual page 175

XW2D-20G6 (M3 screw terminal block)
Dimensions
Precautions
for Correct Use
Round Crimp Terminals
3.2-mm dia.
5.8 mm max.
Applicable Crimp Terminals
Round Crimp Terminals
Fork Terminals
The diagram on the next page shows a typical connection between a host device and the Servo
Drive using a MECHATROLINK-II communications cable.
3-4 Cable and Connector Specifications
79
57
Two, 4.5 dia.
When using crimp terminals, use crimp terminals with the following
dimensions.
When connecting wires and crimp terminals to a terminal block, tighten
them with a tightening torque of 0.7 N·m.
Fork Terminals
3.2 mm 5.8 mm max.
1.25-3
1.25Y-3
(39.1)
17.6
39
Applicable Wires
AWG22-16
2
(0.3 to 1.25 mm )
AWG22-16
2
(0.3 to 1.25 mm )
3
3-76