User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
users passwd
This command changes the password of an existing operator. User password should not be more
than eight characters in length. If a user is authorized for authentication or encryption is enabled,
password must be eight alphanumeric characters in length. The username and password are not
case-sensitive. When a password is changed, a prompt will ask for the operator's former password.
If none, press enter.
Default
Format
Mode
no users passwd
This command sets the password of an existing operator to blank. When a password is changed, a
prompt will ask for the operator's former password. If none, press enter.
Format
Mode
users snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The valid
accessmode values are
the specified access mode will apply.
Default
Format
Mode
no users snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified login user as readwrite for
admin user; readonly for all other users. The <username> is the login user name for which the
specified access mode will apply.
Format
Mode
Switching Commands
No Password
users passwd <username>
Global Config
no users passwd <username>
Global Config
or
readonly
readwrite
for admin user;
readwrite
users snmpv3 accessmode <username> {readonly | read-
write}
Global Config
no users snmpv3 accessmode <username>
Global Config
202-10009-01_060204
. The <
is the login user name for which
username>
readonly
for all other users
8-93