Show Network; Config Network Parms; Config Network Protocol - NETGEAR GSM7324 Reference Manual

show network

This command displays network configuration settings that are vital for switch operation.
Format
IP Address
Subnet Mask
Default Gateway
BurnedIn MAC Address
Network Configuration Protocol Current
Web Mode
Java Mode

config network parms

This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the
gateway must be on the same subnet.
Format

config network protocol

This command specifies the network configuration protocol to be used. If you modify this value
change is effective immediately.(See "save config" on page 63.)
Default
Format
Switching Commands
7000 Series L3 Managed Switch Reference Manual for Software v1.0
show network
The IP address of the interface. The factory default value is
0.0.0.0
The IP subnet mask for this interface. The factory default value is
0.0.0.0
The default gateway for this IP interface. The factory default
value is 0.0.0.0
The burnedin MAC address used for in-band connectivity.
Indicates which network protocol is being used. The
options are bootp|dhcp|none.
Specifies if the switch should allow access from a web browser.
Enabled means the switch can be managed from a web browser.
The factory default is enabled.
Specifies if the switch should allow access to the Java applet in
the header frame. Enabled means the applet can be viewed. The
factory default is enabled.
config network parms <ipAddr> <netmask>
[gateway]
none
config network protocol <none|bootp|dhcp>,
where bootp indicates that the switch periodically sends
requests to a Bootstrap Protocol (BootP) server or a dhcp server
until a response is received. none indicates that the switch
should be manually configured with IP information.
May 30, 2003 Beta Draft
7-15