Accessing The Cli - NETGEAR ProSafe GSM7224P User Manual

You can also enter a question mark (?) after typing one or more characters of a word to list
the available command or parameters that begin with the letters, as shown in the following
example:
(switch) #show m?
mac-addr-table

Accessing the CLI

You can access the CLI by using a direct console connection or by using a telnet or SSH
connection from a remote management host.
For the initial connection, you must use a direct connection to the console port. You cannot
access the system remotely until the system has an IP address, subnet mask, and default
gateway. You can set the network configuration information manually, or you can configure
the system to accept these settings from a BOOTP or DHCP server on your network. For
more information, see
ProSafe Managed Switch
mac-address-table
Network Interface Commands
Using the Command-Line Interface
20
monitor
on page 591.