Snmp-Server Enable Traps Multiusers; Snmp-Server Enable Traps Stpmode - NETGEAR ProSafe GSM7212 Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200 Series Layer-2 Switches, Software Ver-
10.1.11.1 no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
Format
Mode

10.1.12 snmp-server enable traps multiusers

This command enables Multiple User traps. When the traps are enabled, a Multiple User
Trap is sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an
existing terminal interface session.
Default
Format
Mode
10.1.12.1 no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format
Mode

10.1.13 snmp-server enable traps stpmode

This command enables the sending of new root traps and topology change notification
traps.
Default
Format
Mode
10.1.13.1 no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification
traps.
Format
Mode
10-6
no snmp-server enable traps linkmode
Global Config
enabled
snmp-server enable traps multiusers
Global Config
no snmp-server enable traps multiusers
Global Config
enabled
snmp-server enable traps stpmode
Global Config
no snmp-server enable traps stpmode
Global Config
v1.0, March 2006
SNMP Commands