Switch Utility Commands (Including File System Commands) - D-Link xstack DGS-3612G Instruction Manual

S U
WITCH
The download/upload commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
download
upload
config firmware image
show configuration
config configuration
erase
rename
dir
show system boot_file
show storage_media_info
ping
traceroute
enable autoconfig
disable autoconfig
show autoconfig
Each command is listed, in detail, in the following sections.
download
Purpose
Syntax
Description
Parameters
xStack DGS-3612G Layer 3 Gigabit Ethernet Managed Switch CLI Manual
C
TILITY OMMANDS
Parameters
[firmware_fromTFTP <ipaddr> <path_filename 64> {<path_filename 64>} |
config_fromTFTP <ipaddr> <path_filename 64> {<path_filename 64>}]
[cfg_toTFTP <ipaddr> <path_filename 64> {<path_filename 64>} |
log_toTFTP <ipaddr> <path_filename 64> {<path_filename 64>}]
<path_filename 64> boot_up
[current_config | startup_config | <path_filename 64>]
<path_filename 64> [boot_up | active]
<path_filename 64>
<source_path_filename 64> <target_path_filename 64>
<path_filename 64>
<ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
<ipaddr> {ttl <value 1-60> | port <value 30000-64900> | timeout <sec 1-
65535> | probe <value <1-9>}
Used to download and install new firmware or a Switch configuration file from a
TFTP server.
download [firmware_fromTFTP <ipaddr> <path_filename 64>
{<path_filename 64>} | config_fromTFTP <ipaddr> <path_filename 64>
{<path_filename 64>}]
This command is used to download a new firmware or a Switch configuration file
from a TFTP server. The user now has the option of saving the firmware or
configuration file on the FLASH memory located in the Switch using the
previously allocated c:/ drive.
firmware_fromTFTP − Download and install new firmware on the Switch from a
TFTP server.
• <ipaddr> − The IP address of the TFTP server.
• <path_filename 64> − The DOS path and filename of the firmware file
on the TFTP server. For example, C:\3226S.had.
•
{<path_filename 64>} – The second path_filename in the command
refers to the FLASH memory located on the switch. This drive is
nominated c: and those who wish to save the firmware, instead of
uploading it directly to the NV-RAM must specify the path on the
FLASH memory to place this file (ex. c:/firm1). The filename cannot
(I F
NCLUDING ILE
46
8
S C
YSTEM OMMANDS
)