DGS-3100 Gigabit Ethernet Switch Manual
The Broadcast Storm Control commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
config traffic control
show traffic control
Each command is listed in detail, as follows:
config traffic control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure traffic control an
B
ROADCAST
Parameter
{[<portlist> | all] state [enable | disable] | sto
broa
dcast_multicast | broadcast_multicast_dlf ] threshold <int 3500-1000000>}
{port
s <portlist>}
To configure broadcast / multicast traffic control.
config
traffic control {[<portlist> | all] state [enable | disable] |
storm_type [broadcast | broadcast_multicast |
broadcast_multicast_dlf ] th
The config traffic control command configures broadcast and
multicast storm control.
<portlist> - A port or range of ports to be configured.
all − Specifies all ports on the Switch are to
e – The type of broadcast storm for which to configure the
storm_typ
traffic con
trol. The options are:
•
broadcast – Enables broadcast storm control only.
•
roadcast_multicast – Enables broadcast and multicast
b
storm control.
500-1000000> − The upper threshold at which the specified
<int 3
traffic
control is switched on. The value is the number of
broadcast/multicast/dlf packets, in Kbps, received by the Switch that
will trigger the storm traffic control measures. The value ranges in
size from 3500 to 1000000 Kbps.
Only administrator-level users can issue this command.
d enable broadcast storm control system wide:
DGS3100
# config traffic control ports all state enable
Success.
DGS3100
# config traffic control storm_type broadcast threshold 15000
Success.
DGS3100
# config traffic control threshold 15000
S
C
TORM
ONTROL
rm_type [broadcast |
reshold <int 3500-1000000>}
76
11
C
OMMANDS
be configured.