Right High Beam Output Short - Dodge ZB 2005 Service Manual

EXTERIOR LIGHTING
Symptom:

RIGHT HIGH BEAM OUTPUT SHORT

When Monitored and Set Condition:
RIGHT HIGH BEAM OUTPUT SHORT
When Monitored: Output is ON to OFF transition.
Set Condition: When Output is ON to OFF transition and voltage is detected low at
output for less then 50 micros seconds.
INTERMITTENT CONDITION
RIGHT HIGH BEAM OUTPUT CIRCUIT SHORTED
HIGH BEAM HEADLAMP
BODY CONTROL MODULE
TEST
1 Turn the ignition on.
With the DRBIII , clear all BCM DTC's.
Actuate the High Beams.
With the DRBIII , read the DTC information.
Does the DRBIII read: Right High Beam Output Short?
Yes → Go To 2
→ The condition that caused the symptom is currently not present.
No
2 Turn the ignition off.
Disconnect the Right High Beam Headlamp connector.
Disconnect the BCM C2 harness connector.
Measure the resistance between the Right High Beam Output circuit and ground.
Is the resistance below 100.0 ohms?
Yes → Repair the Right High Beam Output circuit for a short to ground.
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced,pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
202
APPLICABILITY
All
All