Dodge ZB 2005 Service Manual page 1747

POWER WINDOWS
*DRIVER WINDOW INOPERATIVE —
TEST
4 Gain access to and disconnect the Driver Power Window Motor connector
Using a 12-volt test light connected to ground, check the Driver Window Down Driver
circuit.
With the DRBIII , actuate the DRV WINDOW DN..
Does the test light illuminate brightly when the DRV WINDOW DN circuit is
actuated?
Yes → Replace the Body Control Module.
→ Go To 5
No
5 Gain access to and disconnect the Driver Power Window Motor connector
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Driver Window Down Driver circuit between the BCM
C2 connector and the Window Motor connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
→ Repair the Driver Window Down Driver circuit for an open.
No
6 Gain access to and disconnect the Driver Power Window Motor connector
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Driver Window Up Driver circuit between the BCM C2
connector and the Window Motor connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
→ Repair the Driver Window Up Driver circuit for an open.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
366
APPLICABILITY
All
All
All