Dodge ZB 2005 Service Manual page 1673

POWER DOOR LOCKS/RKE
DECKLID RELEASE OUTPUT OPEN —
TEST
3 Disconnect the Decklid Release Solenoid.
Using a 12-volt test light connected to ground, check the Decklid Release Driver
circuit at the solenoid connector..
Turn the ignition on.
Try to operate the Decklid Release several times.
Does the test light illuminate brightly when the decklid is activated?
Yes → Replace the Decklid Release Solenoid.
→ Go To 4
No
4 Turn the ignition off.
Disconnect the Decklid Release Solenoid connector.
Disconnect the BCM C2 harness connector.
Measure the resistance of the Decklid Release Driver circuit between the BCM C2
connector and the Solenoid connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
→ Repair the Decklid Release Driver circuit for an open.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
292
APPLICABILITY
All
All