Dodge ZB 2005 Service Manual page 1467

AIRBAG
PASSENGER AIRBAG ON - OFF SWITCH SHORT TO BATTERY —
Continued
TEST
3 Measure the PAB On-Off Switch resistance between terminals 1 and 2 in both switch
positions.
The switch resistance specifications are: ON position = 175.0 to 190.0 ohms and OFF
position = 820.0 to 870.0 ohms.
Is the resistance within range for both switch positions?
Yes → Go To 4
→ Replace the Passenger Airbag ON-OFF Switch.
No
4 WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED.
Disconnect the Airbag Control Module connector
NOTE: Check connectors - Clean and repair as necessary.
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
Measure the voltage on the PAB MUX Switch Sense and PAB MUX Switch Return
circuits at the PAB On-Off Switch connector.
Is there any voltage on either circuit?
Yes → Repair the Passenger Airbag MUX Switch circuits shorted to
→ Go To 5
No
5 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE
PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
If there are no possible causes remaining, view repair.
Repair
ACTION
Perform AIRBAG VERIFICATION TEST - VER 1.
battery.
Perform AIRBAG VERIFICATION TEST - VER 1.
Replace the Airbag Control Module in accordance with Service
Instructions.
Perform AIRBAG VERIFICATION TEST - VER 1.
86
APPLICABILITY
All
All
All