Dodge ZB 2005 Service Manual page 1472

Symptom:
PASSENGER OFF INDICATOR CIRCUIT SHORT TO BATTERY
When Monitored and Set Condition:
PASSENGER OFF INDICATOR CIRCUIT SHORT TO BATTERY
When Monitored: When the ignition is on, the ACM monitors the PAB Indicator Driver
circuit for voltage from the PAB On - off Indicator circuit.
Set Condition: The code will set if the ACM senses battery voltage on the PAB Indicator
Driver circuit.
SHORTED GAUGE CLUSTER CIRCUITS
PAB INDICATOR CIRCUIT SHORT TO BATTERY
ACM, PASSENGER INDICATOR DRIVE CIRCUIT SHORTED TO BATTERY
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST
1 Turn the ignition on.
NOTE: Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 WARNING: TURN THE IGNITION OFF, DISCONNECT THE BATTERY AND
WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Gauge Cluster C1 connector.
NOTE: Check connectors - Clean and repair as necessary.
Measure the resistance between cavity 1 and 3 of the Gauge Cluster C1 connector.
Is the resistance below 1350 ohms?
Yes → Repair or replace the Passenger Airbag Off Indicator in accor-
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Go To 2
Go To 4
dance with the Service Information.
Perform AIRBAG VERIFICATION TEST - VER 1.
91
AIRBAG
APPLICABILITY
All
All