COMMUNICATION
Symptom:
PCI INTERNAL FAULT
When Monitored and Set Condition:
PCI INTERNAL FAULT
When Monitored: With the ignition in the run position.
Set Condition: The DTC will set if the BCM detects a PCI internal fault.
PCI INTERNAL FAULT
TEST
1
Connect the DRB to the Data Link Connector.
Turn the ignition on.
With the DRB, erase BCM DTC's.
Turn the ignition off then turn the ignition on.
With the DRB, read BCM DTC's.
Did this DTC reset?
Yes → Replace the Body Control Module in accordance with the service
→ Test Complete.
No
POSSIBLE CAUSES
ACTION
information.
Perform BODY VERIFICATION TEST - VER 1.
152
APPLICABILITY
All