Dodge ZB 2005 Service Manual page 1633

IGNITION, POWER, ACCESSORY
BCM - IOD OUTPUT CIRCUIT SHORT TO GROUND —
TEST
3 NOTE: All modules and components identified in the previous test must be
disconnected and the DTC must still be present for the result of this test to
be valid.
Turn the ignition off.
Disconnect the Body Control Module C2, C3 and C4 harness connectors.
Measure the resistance between ground and the IOD - B(+) circuit in the BCM C3
and C4 harness connectors.
Is the resistance below 1000.0 ohms?
Yes → Repair the IOD - B(+) circuit for a short to ground.
→ Replace the Body Control Module (BCM) in accordance with the
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
service information.
Perform BODY VERIFICATION TEST - VER 1.
252
Continued
APPLICABILITY
All