Dodge ZB 2005 Service Manual page 1751

POWER WINDOWS
*PASSENGER WINDOW INOPERATIVE —
TEST
13 Remove the Passenger Window Up Relay.
Measure the voltage of the Fused B+ circuit in the Passenger Window Up Relay
connector.
Is the voltage above 10.0 volts?
Yes → Replace the Relay.
→ Repair the Fused B+ circuit for an open.
No
14 Remove the Passenger Window Up Relay (located under the dash just above the
steering column).
Using a 12-volt test light connected to ground, check the Passenger Window Up Relay
Control circuit.
With the DRBIII , actuate the PASS WINDOW UP.
Does the test light illuminate brightly when the PASS WINDOW UP circuit is
actuated?
Yes → Go To 15
→ Go To 16
No
15 Remove the Passenger Window Up Relay.
Using a 12-volt test light connected to 12-volts, check both of the Passenger Window
Up Relay Ground circuits.
Does the test light illuminate brightly when connected to both the Ground circuits?
Yes → Replace the Passenger Window Up Relay.
→ Repair the Passenger Window Relay Coil Ground for an open.
No
16 Remove the Passenger Window Up Relay (located under the dash just above the
steering column).
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Passenger Window Up Relay Control circuit between
the BCM C2 connector and the Relay connector..
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
→ Repair the Passenger Window Up Relay Control circuit for an
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
open.
Perform BODY VERIFICATION TEST - VER 1.
Continued
370
APPLICABILITY
All
All
All
All