Dodge ZB 2005 Service Manual page 1685

POWER DOOR LOCKS/RKE
DRIVER DOOR LOCK SWITCH STUCK —
TEST
3 Turn the ignition off.
Disconnect the Body Control Module C2 and C3 connectors.
Measure the resistance between ground and the Driver Door Switch Mux circuit in
the BCM C3 connector.
Is the resistance below 10000.0 (10K) ohms?
Yes → Repair the Driver Door Switch Mux circuit for a partial short to
→ Go To 4
No
4 Turn the ignition off.
Disconnect the Body Control Module C2 and C3 connectors.
Measure the resistance between Driver Door Switch Mux circuit and the Driver Door
Switch Return circuit in the BCM C3 and C2 connectors.
Is the resistance below 10000.0 (10K) ohms?
Yes → Repair the Driver Door Switch Mux circuit for a short to the
→ Replace the Body Control Module.
No
ACTION
ground
Perform BODY VERIFICATION TEST - VER 1.
Driver Door Switch Return circuit.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Continued
304
APPLICABILITY
All
All