Dodge ZB 2005 Service Manual page 1786

Verification Tests —
1. Disconnect all jumper wires and reconnect all previously disconnected components and
connectors.
2. If the Body Control Module (BCM) was replaced, with the DRBIII , program the country code
into the BCM's memory.
3. Program all RKE Transmitters and other options as necessary.
4. If any HVAC door actuator circuits were repaired, with the DRBIII in HVAC, System Tests,
select Actuator Circuit Test.
5. If any HVAC door actuators were replaced/door linkage was repaired, with the DRBIII in
HVAC, System Tests, select HVAC Door Recalibration.
6. Ensure that all accessories are turned off and the battery is fully charged.
7. With the DRBIII , record and erase all DTCs from ALL modules. Start and run the engine
for 2 minutes. Operate all functions of the system that caused the original concern.
8. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII , read
DTCs from ALL modules.
Are any DTC's present or is the original condition still present?
Yes → Repair is not complete, refer to the appropriate symptom.
→ Repair is complete.
No
POWERTRAIN VERIFICATION TEST VER - 1
1. Inspect the vehicle to ensure that all engine components are properly installed and
connected. Reassemble and reconnect components as necessary.
2. Inspect the engine oil for contamination. If oil contamination is suspected, change the oil and
filter.
3. If the PCM was not replaced skip steps 4 through 6 and continue the verification.
4. If the PCM was replaced the correct VIN and mileage must be programmed or a DTC will set
in the ABS and Air Bag modules.
5. In addition, start the vehicle 20 times after the module is replaced. After 20 starts, the new
PCM is in the proper in-field mode and will kill the fuel if it doesn't receive the VTA Status
J1850 message from the BCM.
6. For ABS and Air Bag systems: Enter correct VIN and Mileage in PCM. Erase codes in ABS
and Air Bag modules.
7. Attempt to start the engine.
Is the vehicle still unable to start or are there any DTCs or symptoms remaining?
Yes → Check for any related Technical Service Bulletins and/or refer to the
appropriate Symptoms list (Diagnostic Procedure).
→ Repair is complete.
No
Continued
BODY VERIFICATION TEST - VER 1
VERIFICATION TESTS
405
APPLICABILITY
All
APPLICABILITY
All