Dodge ZB 2005 Service Manual page 1183

DRIVEABILITY - GAS
P0132-O2 SENSOR 1/1 CIRCUIT VOLTAGE TOO HIGH —
TEST
9 NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay
particular attention to all Power and Ground circuits.
If there are no possible causes remaining, view repair.
Repair
ACTION
Replace and program the Powertrain Control Module per Service
Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
62
Continued
APPLICABILITY
All