Passenger Window Switch Open/Short To Voltage - Dodge ZB 2005 Service Manual

Symptom:

PASSENGER WINDOW SWITCH OPEN/SHORT TO VOLTAGE

When Monitored and Set Condition:
PASSENGER WINDOW SWITCH OPEN/SHORT TO VOLTAGE
When Monitored: Whenever the ignition is in the RUN or ACCESSORY position.
Set Condition: When the BCM senses that the voltage on the Passenger Window Switch
Mux circuit is over 4.5 volts for longer than 31 milliseconds.
DTC PRESENT
SWITCH OPEN
PASSENGER WINDOW SWITCH RETURN WIRE OPEN
PASSENGER WINDOW SWITCH MUX WIRE OPEN
PASSENGER WINDOW SWITCH MUX WIRE SHORT TO VOLTAGE
BODY CONTROL MODULE - PASSENGER WINDOW SWITCH MUX CIRCUIT OPEN
BODY CONTROL MODULE - PASSENGER WINDOW SWITCH MUX CIRCUIT SHORT TO VOLT-
AGE
BODY CONTROL MODULE - PASSENGER WINDOW SWITCH RETURN OPEN
TEST
1 Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run.
Try to operate the Passenger Window Motor by using the Passenger Window Switch.
With the DRBIII , read DTCs.
Does the DRBIII
VOLTAGE??
Yes → Go To 2
→ The condition that caused the code to set is not present at this
No
2 Turn the ignition off.
Disconnect the Window Switch connector.
Measure the resistance between ground and the Passenger Window Switch Return
circuit.
Is the resistance below 5.0 ohms?
→ Go To 3
No
Yes → Go To 4
POSSIBLE CAUSES
ACTION
display PASSENGER WINDOW SWITCH OPEN/SHORT TO
time. Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
357
POWER WINDOWS
APPLICABILITY
All
All