Dodge ZB 2005 Service Manual page 1500

PASSENGER SQUIB 1 SHORT TO BATTERY —
TEST
2 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE
DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO THE AIR
IF ACCIDENTALLY DEPLOYED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
Disconnect the Passenger Airbag connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool to the Passenger Airbag connector.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION ON, THEN RECONNECT THE BATTERY.
With the DRBIII , read the active Airbag DTCs.
Does the DRBIII show PASSENGER SQUIB 1 CIRCUIT SHORT TO BATTERY?
Yes → Go To 3
→ Replace Passenger Airbag in accordance with the Service Infor-
No
3 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the Airbag Control Module connector.
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool adaptor to the Airbag Control Module connector.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
ON, THEN RECONNECT THE BATTERY.
Disconnect the Load Tool from the Passenger Airbag connector.
Measure the voltage on the Passenger Squib 1 Line 1 and Line 2 circuits between the
Passenger Airbag connector and ground.
Is there any voltage present?
Yes → Repair Passenger Squib 1 Line 1 or Line 2 circuit short to battery.
→ Replace the Airbag Control Module in accordance with Service
No
ACTION
mation.
Perform AIRBAG VERIFICATION TEST - VER 1.
Perform AIRBAG VERIFICATION TEST - VER 1.
Instructions.
Perform AIRBAG VERIFICATION TEST - VER 1.
Continued
119
AIRBAG
APPLICABILITY
All
All