Tire Pressure Monitor Module Failure - Tpm - Dodge ZB 2005 Service Manual

TIRE PRESSURE MONITORING
Symptom:

TIRE PRESSURE MONITOR MODULE FAILURE - TPM

When Monitored and Set Condition:
TIRE PRESSURE MONITOR MODULE FAILURE - TPM
When Monitored: Ignition ON. Vehicles speed over 33Km/h (20 mph). Every 60-68
seconds.
Set Condition: When the TPM Module does not receive a transmission from one or more
Tire Pressure Sensor/Transmitters while the Low Tire Pressure Signal circuit returns to
low for more then three seconds. (Receiver failure in TPM Module and TPM Diagnostic
fault in BCM.)
NO TIRE PRESSURE SENSOR/TRANSMITTERS
TIRE PRESSURE SENSOR/TRANSMITTER NOT PROGRAMMED
TIRE PRESSURE MONITOR MODULE FAILURE
TEST
1 Turn the ignition off.
Inspect all four vehicle wheels for the Tire Pressure Sensor/Transmitters being
present using the Miller tool 9001 RF detector.
Do all wheels have Tire Pressure Sensor/Transmitters transmitting?
Yes → Go To 2
→ Replace and program the Tire Pressure Sensor/Transmitter in
No
2 Turn the ignition on.
With the DRBIII and special tool 8192, program the Tire Pressure Monitor Module
for all four Tire Pressure Sensor/Transmitters.
Without the DRBIII connected, road test the vehicle above 33 Km/h (20 mph) for at
least ten minutes.
With the DRBIII , read the last 32 transmissions received by the Tire Pressure
Monitor Module.
Does the DRBIII display any of the Tire Pressure Sensor/Transmitter ID's in the
last 32 transmissio
Yes → Repair is complete.
→ Replace and program the Tire Pressure Monitor Module in
No
POSSIBLE CAUSES
ACTION
accordance with the Service Information.
Perform TIRE PRESSURE MONITORING SYSTEM VERIFICA-
TION TEST.
Perform TIRE PRESSURE MONITORING SYSTEM VERIFICA-
TION TEST.
accordance with the Service Information.
Perform TIRE PRESSURE MONITORING SYSTEM VERIFICA-
TION TEST.
378
APPLICABILITY
All
All