Dodge ZB 2005 Service Manual page 1573

EXTERIOR LIGHTING
LOW BEAM RELAY COIL OUTPUT OPEN/SHORT TO GROUND —
Continued
TEST
4 Turn the ignition off.
Remove the Headlamp Relay from the Power Distribution Center.
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Headlamp Relay Control circuit at the Headlamp
Relay connector to ground.
Is the resistance below 5.0 ohms?
Yes → Repair the Headlamp Relay Control circuit for a short to ground.
→ Go To 5
No
5 Turn the ignition off.
Remove the Headlamp Relay from the Power Distribution Center.
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Headlamp Relay Control circuit between the BCM
connector and the Headlamp Relay connector.
Is the resistance below 5.0 ohms?
Yes → Replace the Body Control Module.
→ Repair the Headlamp Relay Control circuit for an open.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
192
APPLICABILITY
All
All