Dodge ZB 2005 Service Manual page 1328

*NO CRANK CONDITION —
TEST
4 Remove the Push Button Starter Switch.
Disconnect the Push Button Starter Switch harness connector.
Ignition on, engine not running.
Using a 12-volt test light connected to ground, probe the (G5) Fused Ignition Switch
Output circuit in the Switch harness connector.
Does the test light illuminate brightly?
Yes → Go To 5
→ Repair the open or short to ground in the (G5) Fused Ignition
No
5 Measure the resistance between the two terminals on the Push Button Starter
Switch with the Switch released and pressed.
Does the resistance change from an open circuit to below 5.0 ohms?
Yes → Go To 6
→ Replace the Push Button Start Switch.
No
6 Turn the ignition off.
Connect the Push Button Starter Switch harness connector and properly install the
Switch.
Disconnect the Clutch Interlock Switch harness connector.
Ignition on, engine not running.
Using a 12-volt test light connected to ground, probe the (F145) Fused Ignition
Switch Output circuit in the Clutch Interlock harness connector.
While observing 12-volt test light, push the Push Button Starter Switch in the start
position.
Does the test light illuminate brightly?
Yes → Go To 7
→ Repair the open or short to ground in the Fused Ignition Switch
No
7 Shift the transmission into Neutral and apply the Parking Brake.
Connect a jumper wire between the two terminals of the Clutch Pedal Position
Switch and attempt to start the engine.
Does the engine crank?
Yes → Replace the Clutch Interlock Switch.
→ Go To 8
No
NOTE: Remove the jumper wire and properly install the Switch before
continuing.
Continued
ACTION
Switch Output circuit. Inspect related fuses and repair as neces-
sary.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Output circuit. Inspect related fuses and repair as necessary.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
Perform POWERTRAIN VERIFICATION TEST VER - 1.
207
STARTING
APPLICABILITY
All
All
All
All