Dodge ZB 2005 Service Manual page 1525

CHIME
*CHIME INOPERATIVE —
TEST
4 Turn the ignition off.
Reconnect the BCM if disconnected in previous step.
Disconnect the Instrument Cluster harness connectors.
Turn the ignition on.
With the DRBIII , actuate the CHIME. (BCM actuator)
Using a 12-volt test light connected to 12-volts, check the chime driver circuit at the
Instrument Cluster connector.
Does the test light illuminate ON and OFF?
Yes → Replace the Instrument Cluster.
No
5 Turn the ignition off.
Disconnect the Instrument Cluster harness connectors.
Disconnect the BCM harness connector(s).
Measure the resistance of the chime driver circuit between the Instrument Cluster
connector and the BCM connector.
Is the resistance below 5.0 ohms?
No
Yes → Replace the BCM.
Continued
ACTION
Perform BODY VERIFICATION TEST - VER 1.
→ Go To 5
→ Repair the chime driver circuit for an open, between the Instru-
ment Cluster and the BCM.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
144
APPLICABILITY
All
All