Bus System Communication - Dodge ZB 2005 Service Manual

GENERAL INFORMATION
3.4.4 OTHER CHIME ON CONDITIONS
Bulb Check:
The chime will sound three times during the bulb
check.
Diagnostic Trouble Codes set in the BCM:
Chime will sound with the driver's door open and
the ignition key removed from the ignition switch if
any Dome Lamp switch or Ignition switch DTC's
are set in the BCM.
Programming of an Additional Key Fob:
A double chime will sound, which signals that the
program mode has been initiated.
Programming for Rolling Door Locks:
When the programming has been completed, a
single chime will sound.
3.5 COMMUNICATION
The Programmable Communication Interface or
PCI Bus is a single wire multiplexed network capa-
ble of supporting binary encoded messages shared
between multiple modules. The PCI bus circuit is
identified as D25 and is white with a violet tracer.
Additional tracer colors may be added to the violet
in order to distinguish between different module
connections. The modules are wired in parallel.
Connections are made in the harness using splices.
The following modules are used on the ZB/SRT-10:
•
Body Control Module
• Airbag Control Module
• Controller Antilock Brake
•
Powertrain Control Module
• Radio
• A/C Heater Control Module (MTC)
• Mechanical Instrument Cluster
Each module provides its own bias and termina-
tion in order to transmit and receive messages. The
bus voltage is at zero volts when no modules are
transmitting and is pulled up to about seven and a
half volts when modules are transmitting. The bus
messages are transmitted at a rate averaging 10800
bits per second. Since there is only voltage present
when the modules transmit and the message length
is only about 500 milliseconds, it is ineffective to try
and measure the bus activity with a conventional
voltmeter. The preferred method is to use the
DRBIII lab scope. The 12v square wave selection
on the 20-volt scale provides a good view of the bus
activity. Voltage on the bus should pulse between
zero and about seven and a half volts. Refer to the
following figure for some typical displays.
The PCI Bus failure modes are broken down into
two categories. Complete PCI Bus Communication
Failure and individual module no response. Causes
of a complete PCI Bus Communication Failure
include a short to ground or battery on the PCI
circuit. Individual module no response can be
caused by an open PCI circuit at either the module,
or an open battery or ground circuit to the affected
module.
Symptoms of a complete PCI Bus Communication
Failure would include but are not limited to:
•
All gauges on the MIC stay at zero
•
All telltales on MIC illuminate
• MIC backlighting at full intensity
• No response received from any module on the PCI
bus (except the PCM)
• No start
Symptoms of Individual module failure could
include any one or more of the above. The difference
would be that at least one or more modules would
respond to the DRBIII .
Diagnosis starts with symptom identification. If a
complete PCI Bus Communication Failure is sus-
pected, begin by identifying which modules the
vehicle is equipped with and then attempt to get a
response from the modules with the DRBIII . If any
modules are responding, the failure is not related to
the total bus, but can be caused by one or more
modules PCI circuit or power supply and ground
circuits. The DRBIII may display "BUS +/- SIG-
NAL OPEN" or "NO RESPONSE" to indicate a
communication problem. These same messages will
be displayed if the vehicle is not equipped with that
particular module. The CCD error message is a
default message used by the DRBIII and in no way
indicates whether or not the PCI bus is operational.
The message is only an indication that a module is
either not responding or the vehicle is not equipped.
10