Vtss Indicator Output Short - Dodge ZB 2005 Service Manual

VEHICLE THEFT/SECURITY
Symptom:

VTSS INDICATOR OUTPUT SHORT

When Monitored and Set Condition:
VTSS INDICATOR OUTPUT SHORT
When Monitored: When the output is on.
Set Condition: When the output is on and the BCM detects no voltage for at least 125
milliseconds on the VTSS Lamp Output circuit, this code will set.
INTERMITTENT CONDITION
VTSS INDICATOR DRIVER CIRCUIT SHORT TO GROUND
VTSS INDICATOR
BODY CONTROL MODULE
TEST
1 Turn the ignition on.
With the DRBIII , erase DTCs.
Turn the ignition off, wait 15 seconds, then turn the ignition on.
With the DRBIII in Body Computer, read DTCs.
Did this DTC reset?
Yes → Go To 2
→ The condition is not present at this time. Monitor DRBIII
No
2 Turn the ignition off.
Disconnect the VTSS Indicator harness connector.
Turn the ignition on.
With the DRBIII in Body Computer, read DTCs.
Does the DRBIII display VTSS Indicator Output Open ?
Yes → Replace the VTSS Indicator in accordance with the Service
→ Go To 3
No
POSSIBLE CAUSES
ACTION
parameters while wiggling the related wire harness. Refer to any
Technical Service Bulletins (TSB) that may apply. Visually in-
spect the related wiring harness and connector terminals.
Perform VTSS VERIFICATION TEST - 1A.
Information.
Perform VTSS VERIFICATION TEST - 1A.
388
APPLICABILITY
All
All